Troubleshooting - Scheppach Workzone Titanium+ AERO 2 SPADE Original Instructions Manual

AUS

Troubleshooting

XII. Troubleshooting
Problem
Device
does
not start or lacks
power.
Tool no longer
latches into the
tool receiver or
does not lock into
place.
Tool cannot be in-
serted or removed.
Device operates
continuously
without the trigger
lever being actu-
ated.
22
 support@scheppach.com.au
MODEL: AERO SPADE PRODUCT CODE: 59540 04/2018
2
Possible Cause
Piston jammed (rusted) in the
housing due to a lack of oil.
Dirt has penetrated via the air
hose.
Too much lubricating oil used or
water in the striking mechanism.
Pressing force too high.
Output power of the air source
too low.
Tool or tool receiver worn out.
(Most often caused by excessive
pressure or no-load strokes).
Dirt in the sliding sleeve pre-
vents unlocking.
Valve defective.
AERO
Help
Press the piston back with a strik-
ing bolt through the tool receiver.
Introduce a little oil into the
connection hose and into the tool
receiver.
Run the device briefly without a
tool.
Repeat this process a few times.
Repair must be carried out by a
specialist workshop.
Run the device briefly without a
tool.
Grease tool receiver and reduce
pressing force.
Use an air source with a higher
output power.
Repair must be carried out by a
specialist workshop.
Repair/cleaning must be carried
out by a specialist workshop.
Repair must be carried out by a
specialist workshop.
AFTER SALES SUPPORT

SPADE
2
1300 855 831 1300 130 570