Table of Contents
Advertisement
AUS
Before starting the equipment
VI. Before starting the equipment
Check the device, all tools and accessory parts for visible damage before use. Da-
maged tools shall not be used.
An adequately powerful compressed air source (e.g. compressor) of 3 to 6.3 bar
and a suction performance of at least 160 l/min is required for the air supply for the
compressed air device.
m Attention! Danger of device damage if the operating pressure at the device is
more than 6.3 bar.
The following compressors are recommended:
24 litres
50 litres
100 litres and more
The compressor should be operating type S1 (continuous operation)
Connection
Connect a complete compressed air maintenance unit with a mist lubricator, bet-
ween the compressed air source and the device. A maintenance unit can be obta-
ined from specialist dealers and is not included in the delivery.
The compressed air hose (not included in the delivery) should not be longer than 15
metres and should have an internal diameter of at least 9 mm in order to minimise
pressure loss. m Attention! Danger of tripping due to improperly laid compressed
air hoses! Lay the compressed air hoses such that they do not cross paths and such
that they are flat to the floor. Always lay the compressed air hoses such that there is
a reasonable amount of spare hose length in the work area.
Note that the line oiler should be attached at the same floor level or storey as the
working device.
Lubrication
• If the insertion end (hex.) of the tool being used is lightly moistened with oil after
operation, the oiler is correctly set.
• If oil emerges at the valve on the actuation body or if it runs along the tool attach-
ment, the oil quantity is set too high.
• Adjust oil quantity and top up oil
• Please use special compressed air oil - important: Use only resin-free oil!
16
support@scheppach.com.au
MODEL: AERO
SPADE PRODUCT CODE: 59540 04/2018
2
Light work
Moderate work
Heavy work
AFTER SALES SUPPORT
AERO
SPADE
2
1300 855 831
Advertisement
Table of Contents
