Aiwa CA-DW235 Operating Instructions Manual page 7

3-MODE
"c:;
QSOUND
Ill II II
'REc----fll:,,,,,', ,,:~
II
1
—
—
_—
VOLUME
VOLUME
Press VOLUME
A
or 7. The volume level is displayed as
a number from O to MAX (25).
The volume level is automatically set to 14 if the power is
turned off when the volume level is set to 15 or more.
To display the vollume level when CD function is
selected
Press VOLUME
A
or 7. The volume level is displayed for
4 seconds.
3-MODE EQUALIZER
Press one of the 3-MODE EQUALIZER buttons and the
indicator of the selected setting lights up. To cancel, press
the selected setting.
ROCK - Emphasizes the high and low range of music.
POP - Emphasizes voice and midrange of music.
JAZZ - Emphasizes the low range of music.
QSOUND system
This system provides a rich, three dimensional sound area
for stereo sources.
You can enjoy more enhanced sound.
Press QSOUND and the QSOUND indicator lights up.
At higher volumes, turning QSOUND on may cause
sound distortion. In this case, make the volume down.
Connect a microphone with a mini plug to the MIC jack
and play a source to be mixed.
To record the microphone mixing sound, insert a tape in
deck 1 and press REC.
During dubbing at high speed, the microphone mixing
sound is not recorded.
MIC VOL – Adjusts the microphone volume. If a howling
sound is produced, turn the volume down.
To prevent howling, hold the microphone away from the
speakers. The use of unidirectional type microphones is
also recommended.
To listen with the headphones
Connect headphones with a stereo mini plug to the PHONES
jack.
If an erroneous display or malfunction occurs
Make sure that none of the deck operation buttons is
pressed.
Press while pressing POWER/(!) STANDBY.
If the unit cannot be reset in the way above, disconnect the
AC cord and remove all the batteries to turn off the display.
Leave the unit for a while and turn the power back on.
ENGLISH
7