Table of Contents
Advertisement
2.3.6
Override limits
In order to override a set limit, enter the NO LIMITS mode, by pressing SET
once (entering the
SET mode, LED2 is lit) and then holding SET
button again for 3s. When LED2 is blinking fast,
the set limits are ignored while moving with
and
. Move to your new zero or maximum travel
position and hold SET
again for 3s in order to leave the NO LIMITS mode. Now set the new limit
by pressing SET
and then hold OUT
respectively IN
for 3s.
9
Advertisement
Table of Contents
Need help?
Do you have a question about the SteelDrive II and is the answer not in the manual?
Questions and answers