Free Warning Label Replacement; General Maintenance - Craftsman CMXEDAR300 Instruction Manual

English
MAINTENANCE

WARNING: For your own safety, turn the switch
off and remove the plug from the power source
outlet before maintaining or lubricating your
drill press.

General Maintenance

Frequently blow out dust and grit that accumulates in the
motor housing using compressed air.

WARNING: ALWAYS use safety glasses. Everyday
eyeglasses are NOT safety glasses. Also use face or
dust mask if cutting operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
A coat of automotive paste wax applied to the table and
column will help to keep the surface clean.
If replacing the batteries, take out the old batteries and
replace with new AA batteries. When replacing the
batteries, the battery guide should be thoroughly cleaned.
Use a soft paintbrush or similar device, to remove all
sawdust and debris. Dispose off old batteries properly. Do
not mix old and new batteries.
Do not mix alkaline, standard (carbon - zinc), or rechargeable
(nickel - cadmium) batteries. Batteries are to be inserted with
the correct polarity. Do not charge the battery which is not a
rechargeable battery.

WARNING: To avoid shock or fire hazard, if the power
lead is worn or cut in any way, replace it immediately.
LUBRICATION
Ball bearings in the drill press are packed with grease at the
factory and require no further lubrication.
Use only mild soap and a damp cloth to clean the tool.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
iMPORTAnT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service organizations,
always using identical replacement parts.
To clean cast iron parts of rust, you will need the following
materials (not supplied): scouring pad, spray lubricant, can
of degreaser. Apply the spray lubricant and polish with
surface with the scouring pad. Degrease the surface, then
apply a protective product such as an automotive paste
wax.
16

Free Warning Label Replacement

If your warning labels become illegible or are missing, call
1-888-331-4569 for a free replacement.