Assembly And Adjustments - Craftsman CMXEDAR300 Instruction Manual

Hide thumbs

Advertisement


WARNING: Many illustrations in this manual show
only portions of the drill press. This is intentional so
that points being made in the illustrations can be
highlighted. Never operate this drill press without
all guards securely in place and in good operating
condition.

ASSEMBLY AND ADJUSTMENTS

Estimated Assembly Time: 25-35 Minutes.

WARNING: For your safety, never connect plug to
power source receptable until all assembly and
adjustment steps are all complete, and you have
read and understood the safety instructions.

WARNING: The drill press is a heavy power tool
and should be lifted with the help of two people
OR MORE to safely assemble it.
Assembling Column To Base (Fig. D)
1. Remove the rack and rack ring from the column
assembly.
2. Position the base
on a flat and stable work surface
 4 
(must be able to support 100 lbs.).
3. Place the column assembly
the three mounting holes of the column assembly to
the holes of the base.
4. Bag "g" - Locate the three hex bolts
bag.
5. Place a hex bolt
 27 
in each hole through the column
assembly and thread into the base. Tighten with a
13 mm wrench or adjustable wrench.
Fig. D
27
Installing The Table (Fig. E, F, G, H, I)
1. Bag "g" - Install the table lock handle
at the rear of the table bracket
nOTE: Install the handle from left to right, so it enters
the non-threaded side of the table bracket first.
2. Bag "g" - Insert the worm gear
handle hole
 29 
from inside of the table bracket
Make sure the worm gear
gear.
nOTE: Do not remove the lubrication from this worm
gear.
3. Place the rack
 17 
into the inside of table bracket
as shown in Fig. F, making sure the worm gear
the table bracket
 16 
rack
 17 
and the arrow stamped on the rack is pointing
up.
 26 
on the base
 4 
from the parts
 27 
26
4
into the hole
 5 
.
 16 
 28 
into the table crank
 28 
meshes with the inside
is engaged with the teeth of the
4. Slide the table with the rack onto the column. (Fig. G)
5. Engage the bottom of the rack
column assembly. Tighten the table lock handle
lock the table to the column assembly.
nOTE: Do not overtighten.
6. Install the rack ring
the rack sits into the rack ring
nOTE: To avoid column or collar damage, DO NOT
OVERTIGHTEN the set screw

WARNING: The bottom of the collar MUST NOT be
pushed all the way down onto the top of the rack.
MAKE SURE the top of the rack is under the bottom of
the collar and that there is enough clearance to allow
the rack to freely rotate around the column. Tighten
the set screw
7. Install the table crank handle
shaft
 31 
8. Line up the flat side of the shaft with the set screw
in the crank handle and tighten the screw with the
3 mm hex wrench provided. Do not overtighten.
Fig. E
. Align
Fig. F
16
Fig. G
 16 
.
 16 
 28 
in
 17 
onto the column, so the top lip of
 6 
. (Fig. H)
 6 
 30 
.
using the 3 mm hex wrench.
 30 
 15 
onto the worm gear
on the side of the table bracket. (Fig. I)
16
29
17
28
5
17
English
with the lip of the
to
 5 
 32 
28
5
9

Advertisement

loading

  Related Manuals for Craftsman CMXEDAR300