Fitting The Label Inserts - Honeywell Notifier IDR-2P User Manual

997-411-000-9, Issue 9
March 2008
IDR-2P, -2A & -6A Repeaters User Manual

2.5.2 Fitting the Label Inserts

10
With the IDR repeater door open and all power
disconnected, fit the label inserts as follows:
1 a. IDR-2A used with ID50 panel only. Fold
the IDR-2A pushbutton legends (345-429)
at the perforated line. Insert the legends
into the right-hand slot (see arrow '1' on
drawing). The fold rests against the side of
the door. This insert has the legends MUTE
BUZZER through RESET inclusive. Ensure
correct orientation.
b. IDR-2A used with other panels. The
procedure is as given for 1a above, but use
legends with part number 345-420.
c. IDR-6A. The procedure is as given for
1a above, but use legends with part number
345-422.
2 Fold the LH LEDS IDR legends (345-418)
insert FIRE through POWER at the
perforated line. Insert the legends into the
bottom right slot (arrow '2' on drawing). The
fold rests on the bottom of the slot. Ensure
correct orientation.
3 Fold the RH LEDS IDR legends (345-419) insert
PRE-ALARM through COMMUNICATIONS
LOSS at the perforated line. Insert the
legends into the bottom left slot (arrow '3'
on drawing). The fold rests on the bottom
of the slot. Ensure correct orientation.
Note: The IDR repeater is supplied with
legends in a number of languages. Part
numbers given above are for English
language legends.