Ce Marking; System Design And Planning; General - Honeywell Notifier IDR-2P User Manual

Cover the enclosure
front door during
installation, to protect
printed circuit board
997-411-000-9, Issue 9
March 2008
IDR-2P, -2A & -6A Repeaters User Manual
the LCD and the

1.1 CE Marking

The repeater is CE-Marked to show that it
conforms to the requirements of the following
European Community Directives:
Electromagnetic Compatibility Directive 89/
336/EEC (and the amending Directives
92/31/EEC and 93/68/EEC).

1.2 System Design and Planning

It is assumed that the system, of which the
IDR repeater is a part, has been designed by
a competent fire alarm system designer in
accordance with the requirements of EN54
Part 14 and any other local codes of practice
that are applicable.

1.3 General

The IDR repeater has been designed to comply
with the requirements of EN54 Part 2,1997
when used as a secondary display.
The connection between repeaters and fire
control panels can be made either by an RS485
link or by an RS232 link (an optional Isolated
RS232 port can be fitted to allow connection
of Notifier-approved equipment).
Installation
The IDR repeaters are easy to install providing
the recommended procedures described in this
manual are followed. To avoid inadvertant
contamination of the PCB assemblies, the
manufacturer recommends that the enclosure
front door be covered during installation. An
optional Bezel kit containing a back box and bezel
is available for pre-installation, if required.
Commissioning
To commission the IDR repeaters follow the
recommended procedures described in this
manual.
Some fire control panels may require
configuration to associate the repeater with a
specific panel on the RS485 network; the
repeater then repeats that panel. Refer to the
documentation supplied with the fire control
panel for details of how to do this.
Operating
In addition to the repeat display of the fire
control panel, the IDR repeater includes some
repeater-unique menus to test the repeater
operation.
2