Raymarine Dragonfly 6 Installation And Operation Instructions Manual page 85

Units set-up
You can specify your preference for the units of measurement that will be used in all applications.
Menu item
Distance Units
Speed Units
Depth Units
Temperature Units
GPS Set-up menu
The options available from the GPS set-up menu are
shown below.
Menu item Description
View Satellite Displays the GPS
Status status page.
COG/SOG
Refer to the
Filter:
COG/SOG Filter
section for details.
Restart GPS Selecting Restart
GPS will reboot the
internal GPS.
GPS Status
Products with an internal GPS receiver or GNSS
(GPS/GLONASS) receiver can use the GPS status
page to view the status of the available satellites that
are compatible with your receiver.
The satellite constellations are used to position your
boat in the Chart application. You can set up your
receiver and check its status from the GPS Set-up
menu. For each satellite, the screen provides the
following information:
1. Sky view
2. Satellite status
3. Position and fix information
Tools & Settings
Description
The units of measure that will be used in all
applications for the display of all values related
to distance.
The units of measure that will be used in all
applications for the display of all values related
to speed.
The units of measure that will be used in all
applications for the display of all values related
to depth.
The units of measure that will be used in all
applications for the display of all values related
to temperature.
Options
• Low
• Medium (default)
• High
Options
• Nautical Miles
• NM & m (Nautical miles and meters)
• Statute Miles
• Kilometers
• Knots
• MPH (Miles Per Hour)
• KPH (Kilometers Per Hour)
• Feet
• Meters
• Fathoms
• Fahrenheit
• Celsius
Sky view
Sky view is a visual representation that shows
the position of navigation satellites and their type.
Satellite types are:
• Circle — A circle identifies a satellite from the
GPS constellation.
• Square — A square identifies an (SBAS)
differential satellite.
• Diamond — A diamond identifies a satellite from
the GLONASS constellation.
Satellite status area
The Satellite status area displays the following
information about each satellite:
• Type — Identifies which constellation the satellite
belongs to.
• ID — Displays the satellites identification number.
• CNO (Carrier-to-noise ratio) — Displays the signal
strength of each satellite shown in the Sky view:
– Grey = searching for satellite
– Green = satellite in use
– Orange = tracking satellite
• Azimuth and Elevation — Provides the angle of
elevation and azimuth between the location of the
receiver and the satellite.
Position and fix information
The following positional and fix information is
provided:
• Horizontal Dilution of Precision (HDOP)
— HDOP is a measure of satellite navigation
accuracy, calculated from a number of factors
including satellite geometry, system errors in
the data transmission and system errors in the
receiver. A higher figure signifies a greater
positional error. A typical receiver has an accuracy
of between 5 and 15 m. As an example, assuming
a receiver error of 5 m, an HDOP of 2 would
85