Calibration Pendulum Ii Procedure On Tpu, S4Cplus - ABB S4Cplus Instruction

 &DOLEUDWLRQ 3HQGXOXP ,, SURFHGXUH RQ 738 6&SOXV
*HQHUDO
This section details how to use the Teach Pendant Unit (TPU) when calibrating the robot
using the Calibration Pendulum II (CalPend).
3URFHGXUH RQ 738
The procedure below details how to perform the CalPend routine on the TPU.
3HAC 16578-1 Revision: E

3.2.7. Calibration Pendulum II procedure on TPU, S4Cplus

$FWLRQ
1. Press the "Program"
button on the TPU.
2. Select "Special", and
then "Call service
routine".
3. Start the program: "Cal-
pendulum.rutin".
4. Select the required
calibration procedure
and press "START".
,OOXVWUDWLRQ
xx0300000009
xx0200000188
 &DOLEUDWLRQ
&RQWLQXHV RQ QH[W SDJH
65