Viavi MP-60 Quick Card

Viavi MP-60 Quick Card

Usb optical power meter, measuring absolute power on the t-berd/mts-2000

Advertisement

Quick Card
MP-60 and MP-80 USB Optical Power Meter
Measuring Absolute Power on the T-BERD/MTS-2000
The following procedure outlines how to use the VIAVI T-BERD/MTS-2000 equipped with an MP-60
or MP-80 external USB Optical Power Meter.

Equipment Requirements:

• T-BERD/MTS-2000 with Fiber Optics Software
Release V18.0
or greater
• MP-60 or MP-80 USB Optical Power Meter
• Fiber optic cleaning and inspection tools
• Patch Cable with connectors matching the
Power Meter and fiber under test
• Optical Coupler to connect Patch Cable to the
Fiber under Test
The following information is required to complete the test:
• Type of Fiber (Multimode or Single Mode)
• Type of Connectors (SC UPC, SC APC, LC, etc.)
• Wavelength of signal(s) to measure
Figure 2: MP-60/MP-80 USB Power Meter
Figure 1: Equipment Requirements
VIAVI Solutions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MP-60 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Viavi MP-60

  • Page 1 Quick Card MP-60 and MP-80 USB Optical Power Meter Measuring Absolute Power on the T-BERD/MTS-2000 The following procedure outlines how to use the VIAVI T-BERD/MTS-2000 equipped with an MP-60 or MP-80 external USB Optical Power Meter. Equipment Requirements: • T-BERD/MTS-2000 with Fiber Optics Software Release V18.0...
  • Page 2 VIAVI Solutions Connect to Fiber Under Test (FUT): The MP-60/80 may be connected to the Fiber under test via an optical patch panel (OPP) or an optical coupler. All fibers and connectors should be inspected and clean prior to connection: 1.

This manual is also suitable for:

Mp-80

Table of Contents