Working With I-Jet; Setup And Installation; Software; Probe Setup - IAR SYSTEMS I-jet User Manual

Setup and installation

Connecting the target system

Working with I-jet

This chapter describes how to work with I-jet. More specifically, this means:
Setup and installation
●
Connecting the target system.
●
For information about debugging using I-jet, see the C-SPY® Debugging Guide
for ARM.

SOFTWARE

I-jet requires IAR Embedded Workbench for ARM to be installed.

PROBE SETUP

I-jet does not require any special driver software installation. All drivers for I-jet are part
of the installation of IAR Embedded Workbench for ARM.
If you need to install the driver manually, navigate to
\Program Files\IAR Systems\Embedded Workbench x.x\arm\drivers\jet
or (depending on your system). Start the
\USB\32-bit 64-bit
application. This will install the driver.
For information about using multiple I-jet probes on the same PC, see the C-SPY®
Debugging Guide for ARM.

POWER-ON SEQUENCE

When the target power is not provided by I-jet, you do not need to follow any special
powering sequence. Connect I-jet to a powered and running target board and start
debugging.
When hot-plugging, the target GND and the USB host GND must be at the same level.
To prevent damage due to GND differences, make sure that the PC and the target board
power supply are connected to the same wall outlet or a common desktop power strip.
dpinst.exe
9