Table of Contents
Advertisement
Connecting the target system
I-jet®
10
User Guide
POWER UP YOUR EVALUATION BOARD
If you have an evaluation board that is prepared for it, you can power the board via I-jet
through pin 19 on the 20-pin 0.1 in pitch JTAG connector, or pin 11/13 on the small 0.05
in pitch MIPI-20 connector. Target power of up to 400 mA can be supplied from I-jet
with overload protection. Most of the IAR Systems KickStart Kits contain an evaluation
board that can be powered this way.
Note: The target board will get power via I-Jet once you start the compile and
download routine, but not before.
Advertisement
Table of Contents
Need help?
Do you have a question about the I-jet and is the answer not in the manual?
Questions and answers