Related Manuals for Amylior LogoSilver IzyChair
Summary of Contents for Amylior LogoSilver IzyChair
- Page 1 Find this notice at www.logo-silver.fr ULTRA-LIGHT AND COMPACT, CONVENIENT AND EASY ASSEMBLY AND DISASSEMBLY FOR TRAVEL.
-
Page 2: Table Of Contents
CONTENTS INTRODUCTION ......................II. SAFETY ..........................2.1 EXPIRATION DATE ......................2.2 INSTRUCTIONS BEFORE USE ..................2.3 ATTENTION DURING USE ..................2.4 ELECTROMAGNETIC INTERFERENCE ..............III. STRUCTURE AND PERFORMANCE ................. 3.1 STRUCTURE OF THE IZYCHAIR ................3.2 ELECTRIC DIAGRAM OF N5519 ................3.3 PRODUCT SOFTWARE VERSION ................ - Page 3 VIII. SAFETY DEVICES AND ACCIDENT MANAGEMENT .......... 17 IX. MAINTENANCE ......................17 9.1 MOISTURE ......................... 17 9.2 TEMPERATURE ........................17 9.3 GENERAL GUIDELINES ....................17 9.4 MAINTENANCE AFTER USE ..................18 9.5 DAILY CHECKS ........................ 19 9.6 CLEANING ........................19 X.
-
Page 4: Introduction
I. INTRODUCTION Read and follow all instructions, warnings, The symbols below in this manual are and notes in this manual before attempting used to identify warnings and important to operate your power wheelchair for the information. They are all very important first time. -
Page 5: Safety
II. SAFETY USE 2.1EXPIRATION DATE This IZYCHAIR is an anti-bacterial, reusable product without chemical substances. The chair safety and validity period for clinical use not only depends on the structural strength of the products, but also on the user operation and environment, user habits, whether they are in accordance with periodic maintenance, and other additional factors. -
Page 6: Electromagnetic Interference
WARNING! If your wheelchair moves involuntarily, release the joystick immediately and the wheelchair will stop automatically. If the joystick malfunctions and the brake fails, please cut off the power. CAUTION! Please pull the lever upwards when the power chair comes to an incline, or it will roll downward at low speed, resulting in personal injury. -
Page 7: Structure And Performance
Prevention of Electromagnetic Interference • Do not use hand-held radio transceivers such as mobile phones, radios, etc; when the wheelchair power is turned on. • Avoid nearby radio transmission systems, such as radio stations, television stations. • If the power wheelchair is defective or the brakes fail, please contact your company or dealer. -
Page 8: Electric Diagram Of N5519
3.2 ELECTRIC DIAGRAM OF N5519 Right motor Right brake Controller Connectors for right motor Joystick Connectors for battery (24 volts lithium battery) Left brake Connectors for left motor Left motor 3.3 PRODUCT SOFTWARE VERSION • Software version of Power Wheelchair N5519 is V1.8. P·8... -
Page 9: Specification
IV. SPECIFICATION The main specification includes dimension and weight. Accessibility interior Configuration 2 motorised rear wheels General dimensions length: 890 mm width : 560 mm height : 890 mm Folded chair dimensions 320 mm x 680 mm x 690 mm Seat height 460 mm Seat width... -
Page 10: Installation, Folding And Adjustment
V. INSTALLATION, FOLDING AND ADJUSTMENT 5.1 INSTALLATION • Take the wheelchair out of the packing box and put it on the ground. Push the chair- frame apart to the left and right, and press the two tubes on both sides of the seat base down into the grooves on both sides of the chair-frame. -
Page 11: Adjustment
5.3 ADJUSTMENT • When the motor lock lever is pulled downward it is in manual mode, which means that the chair can be pushed manually by an attendant. When the motor lock lever is pulled upward to electric mode, it can’t be pushed manually.(Fig.11) •... -
Page 12: Use And Operation
VI. USE AND OPERATION Battery gauge 6.1 USE Charger socket Horn button 6.1.1 Controller: Speed light It is the key component of a wheelchair. Speed down All electronics operating the latter are housed in it(fig. 12). The controller Speed up is usually installed on one armrest, which is Joystick connected to a motor and battery in the... -
Page 13: Battery Usage
6.1.2 Battery Usage Fully charge your new battery prior to its initial use. This brings the battery up to about 90% of its peak performance level. Give the battery another full charge of 8-14 hours and operate your wheelchair again, the batteries will now perform at over 90% of their potential. After four or five charging cycles, the batteries will top off at 100% charge and last for an extended period. -
Page 14: Overcharge
Charging the batteries using the off-board charger supplied by us: • Verify that the controller is powered off and the wheelchair is in drive mode. • Connect the 3-pin output plug of the charger to the controller. (Fig.13) • Connect the power plug of the charger to the standard wall outlet. •... -
Page 15: Practice Before Operation
6.2.2 Practice before operation • Find a spacious place like a square and have an assistant to help you practice until you have enough confidence to operate it alone. • Be certain to turn off the power when you get into and out of the wheelchair, and set a speed you feel comfortable with. -
Page 16: Fault Diagnosis And Troubleshooting
VII. FAULT DIAGNOSIS AND TROUBLESHOOTING This product has an automatic fault warning function for your convenience. Once it malfunctions, the LEDs on the controller will flash with an alarm sounded by the horn. You can find where a fault is using the information in Table 2. If the problem still exists after checking the fault based on the information in table 2, do not use the wheelchair. -
Page 17: Safety Devices And Accident Management
VIII. SAFETY DEVICES AND ACCIDENT MANAGEMENT • Overcharge protector: Refer to instruction manual 6.1.4 • Safety belt: Refer to instruction manual 6.1.6 • Please release the joystick whenever there is a wheelchair fault, the wheelchair will come to a stop. IX. -
Page 18: Maintenance After Use
• Check all electric connections, including the cable and connectors of the charger, and ensure that they are all tight and secure. • If only red LEDs are displayed on the battery gauge lights, the batteries are running out of charge. You should recharge the batteries as soon as possible. We recommend charging the battery for 8-12 hours. -
Page 19: Cleaning
Items for inspection At any time Weekly Monthly Biannually All parts • Joystick function • Brake System • Connection • Battery Condition • Tire Condition • Frame Condition • Front Wheel Condition • Cleanliness • 9. 6 CLEANING Cleaning instructions: •... -
Page 20: Storage
CAUTION! In order to guarantee the quality of the power wheelchair, please contact us or our dealers to replace the spare parts with the same models and specifications if the parts like the batteries, tyres, controller, motors and charger, etc. need to be replaced. The maintenance should be carried out at our company or the dealers’... -
Page 21: Warranty
XIII. WARRANTY 13.1 FIVE-YEAR WARRANTY Our company has passed the ISO9001 and ISO13485 certificate. The quality is guaranteed. 13.2 COVERED BY WARRANTY: Five years warranty on the front and the rear main frames from the date of purchase. One-year warranty on the following parts from the date of purchase: •... - Page 22 P·22...
- Page 23 P·23...
- Page 24 Logo Silver www.logo-silver.fr 32 rue de Comboire - 38130 Echirolles - France Tél. +33(0)4 76 21 22 19 - contact@logo-silver.fr...
Need help?
Do you have a question about the LogoSilver IzyChair and is the answer not in the manual?
Questions and answers