Horizontal Machine Alignment (Change 2); Horizontal Machine Alignment (Change 3) - Fluke 830 User Manual

7.. Horizontal machine alignment (Change 2)

On pages 60-64, replace the Laser beam adjustment section with:
Laser beam adjustment
After entering all required dimensions, the measurement screen appears auto-
matically.
Press the On/Off switch to turn on the Sensor. Refer to
sensor LEDs
Adjust the Sensor and prism so that the laser beam strikes the prism and is
reflected back into the Sensor.

7.. Horizontal machine alignment (Change 3)

On pages 61-64, replace the Remove prism cap and establish communication
between the sensor and the Product with:
Remove prism cap and establish communication between the
Sensor and the Product
The Product collects measurement data using the Sensor.
Remove the prism dust cap to allow the beam to strike the prism and be reflected
back to the Sensor, and then press
Find Quality Products Online at:
to check the status of the sensor LEDs. The laser is now activated.
. The "Main menu" window opens. Use
MENU
GlobalTestSupply
www.
Table 4-2. Monitoring
17
.com
Addendum
sales@GlobalTestSupply.com