Adjust the Sensor and prism so that the laser beam strikes the prism and is
reflected back into the Sensor.
Do not stare into the beam..
1. Keep the prism dust cap on. If the Sensor and prism are roughly positioned
with each other during mounting, the laser beam should strike the prism dust
cap and is readily visible. If the beam is so far off target that the beam misses
the prism completely, hold a sheet of paper in front of the prism to locate the
beam and readjust it.
2. Make these adjustments:
● Vertical adjustment: slide the prism or Sensor up and down along the
support posts. Use the thumbwheel [
To move the Sensor, loosen the yellow knobs [
The lever [
and dismounting.
1
Figure 7-9.. Horizontal and vertical adjustment of the laser beam
Find Quality Products Online at:
Warning
] on the side of the prism housing.
A
] must always be in the horizontal position except for mounting
C
GlobalTestSupply
www.
].
B
2
3
21
.com
Addendum
sales@GlobalTestSupply.com