Addendum
6.. Getting started (Change 2)
On page 41, in the Wireless measurement section, replace the text after the note
with:
Press the On/Off switch to turn on the Sensor. This initializes the laser beam.
Center the laser dot on the prism dust cap (see Figure 6-2).
On page 43, replace the graphics and text between the graphics with:
Use
/
and highlight 'Scan' then press
to scan nearby sensors.
ENTER
Note
Make sure the Sensor is on.
Once detected, the Sensor is selected automatically.
15
GlobalTestSupply
www.
.com
Find Quality Products Online at:
sales@GlobalTestSupply.com