Number Pad 0-9; Erase Sequence - Roland Kiwitechnics KIWI-SJX Manual

NUMBER PAD 0-9

ERASE
SEQUENCE
www.kiwitechnics.com
Number buttons 1-8 are used for loading
and saving Patches and Tones. Number
buttons 0 & 9 are only used for selecting
editing parameters.
These buttons will select Patches, Tones
or Sequences 1 to 8. The Patch or Tone
will immediately load and the Sequence
will load depending on whether one is
running or not.
The same patch that is selected when the
synth is switched off will load again
automatically when the Kiwi-SJX is
switched on.
A long press of this button will allow a
Sequence to be erased.
In the MKS-70 version the SHIFT must be
pressed first.
When writing a Patch or Tone these
buttons will select the Patch or Tone
number that the Patch or Tone will be
stored under. The Patch or Tone will
be written to memory when the
Number Pad ENTER Button is
pressed.
Note – Write protect must be off to
write to memory. A MEM PROTECTED
message will show on the display if a
write is attempted with the protect on.
To Load a sequence the SEQ LOAD
button must be pressed before the
Number Pad button is pressed.
After this button is long pressed the
sequence number is selected using
the Number Pad buttons 1-8 and then
the WRITE button is pressed.
To Cancel press CANCEL.
JX-SJX Upgrade User Manual v100
20