Technical Specifi Cations - 3M Accuspray 26580 Owner's Manual

• To reduce the risks associated with bursting and chemical exposure:
Do not operate spray gun system without a functional inlet pressure gauge. See pressure recommendations in user's
‐
manual for each spray gun nozzle.
Ensure air and liquid input pressure and all applicator system regulators are properly adjusted per material's
‐
recommendations prior to each use. Do not exceed working pressure per user's manual.
Always follow required air and liquid pressure relief procedures for relieving air and liquid pressure from the spray
‐
equipment.
• To reduce the risks associated with chemical exposure:
Always wear appropriate personal protective equipment for eye, skin, respiratory and hearing protection per the
‐
applicable SDS(s) and material container labels at all times when spraying.
• To reduce the risks associated with hazardous noise:
Always wear hearing protectors when you are exposed to noise. Consult your work environment and local regulations
‐
regarding use of personal protective hearing protection.
• To reduce the risks associated with tripping, falling and tipping:
Route air hoses away from traffi c areas, sharp edges, moving parts and hot surfaces. Do not pull on air hoses to move
‐
the compressor.
• To reduce the risks associated with impact:
Always inspect to ensure that the atomizing head is properly attached and secure.
‐
• To reduce the risks associated with sharp points:
Do not touch the sharp end of the fl uid needle when exposed and handle fl uid needles carefully during replacement.
‐
• To reduce the risks associated with muscle strain:
Avoid using spray equipment continuously without taking occasional breaks.
‐
Dispose of device components in accordance with local laws and regulations.
‐
Ensure equipment is cleaned prior to storage.
‐
Ensure equipment is stored indoors at room temperature.
‐
Do not put in gun washer. Do not leave immersed in cleaning solvents. See manual for appropriate cleaning process.
‐
Solvent left in the spray gun air passages could result in a poor quality coating fi nish. Do not use any cleaning method
‐
which may allow solvent into the spray gun air passages. Do not expose air fl ow control valve and gauges to solvent
as damage may occur.
Technical Specifi cations:
Operator Hand/Arm Vibration level: less than 2.5 m/s²
Declared vibration level in accordance with EN 12096, measurements carried out in accordance with standard EN ISO
28662-1 and EN ISO 20643.
Declared Dual-Number Noise Emission Values according to EN ISO 4871
A-WEIGHTED EMISSION SOUND PRESSURE LEVEL AT THE WORKSTATION:
Measured value: LpA = 71,4 dB(A) (ref 20μPa)
Uncertainty: KpA = 2,5 dB
A-WEIGHTED SOUND POWER LEVEL:
Measured value: LWA = 83,1 dB(A) (ref 1 pW)
Uncertainty: KWA = 2,5 dB
Values determined according to noise test code EN 14462 using the basic standards
EN ISO 11201 - grade 2, and EN ISO 3741
Usage Rated - II 2G Ex h IIB T4
NOTE: The sum of a measured noise emission value and its associated uncertainty represents an upper bound of the range
of values which can occur in the measurements.
CAUTION
NOTICE
5