Knightsbridge BT9EMS Installation & Maintenance Manual

Knightsbridge BT9EMS Installation & Maintenance Manual

Advertisement

Quick Links

INSTALLATION & MAINTENANCE MANUAL
BT9EMS / BT9DEMS / BT14EMS / BT14DEMS
BT20EMS / BT20DEMS
IP
230 V
44
50Hz
02
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BT9EMS and is the answer not in the manual?

Questions and answers

Summary of Contents for Knightsbridge BT9EMS

  • Page 1 INSTALLATION & MAINTENANCE MANUAL BT9EMS / BT9DEMS / BT14EMS / BT14DEMS BT20EMS / BT20DEMS 230 V 50Hz...
  • Page 2 • This product is non-dimmable These instructions should be used to aid installation of the following products: BT9EMS / BT9DEMS / BT14EMS / BT14DEMS / BT20EMS / BT20DEMS INSTALLATION SAFETY • Provide power to the required point of installa •...
  • Page 3 Fig. 3 Fig. 2 Fig. 3 • Remove the LED plate and disconnect from the driver and the emergency inverter via the DC plugs and sockets (see Fig. 3) • Mark the location of the fixing holes, and drill the holes ensuring not to infringe with any gas / water pipes or electrical cables •...
  • Page 4 • Switch on and check for correct operation, ensuring the green LED is illuminated • We recommend, on commissioning the installation, a minimum charge period of 24 hours bef an emergency duration test SENSOR LAYOUT SENSOR LAYOUT Fig. 5 DIP SWITCH LAYOUT DIP SWITCH LAYOUT Fig.
  • Page 5 • This is the time period the lamp remains at 100% after no motion is detected • When set to disable, the daylight sensor will switch the lamp on when motion is detected regardless of the ambient light level WARNING This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing.
  • Page 6 WARNING This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed GENERAL This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities for where facilities exist The batteries in this luminaire are Nickel Cadmium and must be disposed of correctly.
  • Page 7 TEST RECORD SHEET SIGNED DATE INITIAL COMMISSIONING 3 HOUR TEST FIRST YEAR SECOND YEAR THIRD YEAR FOURTH YEAR FIFTH YEAR MONTH TEST SIGNED DATE SIGNED DATE SIGNED DATE SIGNED DATE SIGNED DATE FUNCTIONAL FUNCTIONAL FUNCTIONAL FUNCTIONAL FUNCTIONAL FUNCTIONAL FUNCTIONAL FUNCTIONAL FUNCTIONAL FUNCTIONAL FUNCTIONAL...
  • Page 8 ML Accessories Limited LU5 4LT DCNOV18_V1 www.mlaccessories.co.uk...

This manual is also suitable for:

Bt9demsBt14emsBt14demsBt20emsBt20dems

Table of Contents