Table of Contents
Advertisement
Next steps
1.
Install the mezzanine
2.
Install the expansion card riser
3. Follow the procedure listed in
Removing the OCP card
Prerequisites
NOTE:
The procedure to remove the mezzanine blank is similar to the removal of a mezzanine card.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the mezzanine
Steps
1. Push the blue retention clips away on one side and release the Open Compute Project (OCP) card.
Repeat step 1 to release the card from the clips on the other side.
2. Slide the card toward the front of the sled to disengage the connectors from the chassis and lift the card up.
Figure 69. Removing the OCP card
Next steps
1.
Install the OCP
card.
Installing the OCP card
Prerequisites
1. Follow the safety guidelines listed in
Steps
1. Insert the Open Compute Project (OCP) card into the sled, aligning the connector on the card with the connector in the
system board.
2. You must also align the holes on the card with the guide pins on the blue retention clips.
card.
assembly.
After working inside your
Safety
instructions.
Before working inside your
card.
Safety
instructions.
system.
system.
Installing and removing enclosure components
75
Advertisement
Table of Contents
