Table of Contents
Advertisement
Figure 60. Installing the M.2 SATA x16 riser
Next steps
1.
Install the sled into the
2. Follow the procedure listed in
Removing the M.2 SATA card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the sled from the
4. If applicable,
remove the expansion card riser
5.
Remove the M.2 x16 riser or the M.2 SATA x8 mezzanine
NOTE:
The procedure to remove the M.2 SATA x8 mezzanine card is similar to removing a mezzanine card.
Steps
1. Using the Phillips #1 screwdriver, unscrew the screw that secures the M.2 card to the board.
2. Pull the card out of the connector and lift the card away.
68
Installing and removing enclosure components
enclosure.
After working inside your
Safety
instructions..
Before working inside your
enclosure.
assembly.
system.
system.
card.
Advertisement
Table of Contents
