Table of Contents
Advertisement
Figure 17. Stop the sled at a distance of 20-30 mm before complete insertion
3. Slide the blue retention latch gently, until the sled locks into the place.
Next steps
1. Follow the procedure listed in
NOTE:
To add the Service Tag of the system board to match the Service Tag of the physical node, contact Dell
Technical Support.
PERC battery
Removing the PERC battery
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the sled from the enclosure.
4. If applicable, disconnect the battery cable from the PERC card.
CAUTION:
Do not hold the battery cable and lift the battery out.
Steps
Holding the cable end of the battery, lift the battery out of the air shroud.
26
Installing and removing enclosure components
After working inside your
Safety
instructions.
Before working inside your
enclosure.
system.
Advertisement
Table of Contents
