GE CT-9800 Technical Publications page 78

GE MEDICAL SYSTEMS
Rev. 24
The CHANGE ALL FACTS command should not be used except to reconfigure to a one or two drive
configuration. The information is already entered into the firmware. If you do reconfigure, you must also write the
changes to EEPROM to save them using the "U - Update EEPROM" command (this requires Switch 2 on the
controller board to be changed to the write enable position "UP" position). Be sure to set this switch back to the
"DOWN" or write protect position when finished.
The following is the configuration information for a CT Single ACE drive system:
Enter command (? to see choices): A<CR>
You must have a printer at device code 17 to log your dialogue to a printer.
Do you have such a printer (Y or [N]) ? N<CR>
CT - Computed Tomography
MR - Magnetic Resonance
HTD - High Throughput Dynamic
ND - No Disk
Select Disk (or EN to END disk selection): CT<CR>
How many drives in this system (1-4) ? 1<CR>
Enter BMC priority (0=lowest, 7=highest; S280 and MV4000 0-3 only) [5
What is the throttle burst rate
What is the throttle break count [4
Current Configuration Facts:
----------------------------
Logical
Heads
Sectors
Cylinders
Formt'd megs
Logical blks
To see the partitioning of a logical unit, enter the unit number:<CR>
Microcode on logical unit
BMC priority ...........
Throttle burst rate ....
Break count ............
Enter command (? to see choices): ?U<CR>
Updating...Please wait
If you have changed something and do not wish to have the changes saved use the "[Q]uit" command as
follows:
Enter command (? to see choices): Q<CR>
EEPROM not updated!
After the program has terminated, you may need to do some of the following:
Format or reformat the disk.
Initialize or re-initialize the disk.
Do you want to configure another GESCSI controller (Y/[N]) ?N<CR>
Disk Selection
[32
Logical
Unit 0 Unit 1
1
128
4581
300
586062
0
5
32
4
Do you really want to abandon these edits (Y/N) ? Y<CR>
C1 - CT using 1 ST34520N
M1 - MR using 1 ST34520N
UD - User-defined
For 1 Disk system
] ? <CR>
] ? <CR>
Logical
Unit 2
1 1
128 128
0 0
0 0
0 0
4-3-34
CT 9800 QUICK SYSTEM
Direction 18000
] : <CR>
Logical
Unit 3
1
128
4
0
267