Explanation Of Symbols For The Installation Position - Fronius Tauro 50-3 Operating Instructions Manual

Explanation of
symbols for the
installation posi-
tion
28
The inverter is suitable for outdoor installation.
In order to minimise the heating up of the inverter, it is better to not
expose the inverter to direct insolation. The inverter should be installed
in a protected location, for example, near the solar modules or under
an overhanging roof.
IMPORTANT! The inverter must not be installed or used at altitudes
above 4000 m.
Do not install the inverter in:
- Areas where it may be exposed to ammonia, corrosive gases,
acids or salts (e.g. fertiliser storage areas, vent openings for live-
stock stables, chemical plants, tanneries, etc.)
Due to the noise generated by the inverter under certain operating
conditions, it should not be installed close to living areas.
Do not install the inverter in:
- Areas where there is an increased risk of accidents from farm
animals (horses, cattle, sheep, pigs, etc.)
- Stables or adjoining areas
- Storage areas for hay, straw, chaff, animal feed, fertilizers, etc.
- Storage or processing areas for fruit, vegetables or viticulture
products
- Areas used in the preparation of grain, green fodder or animal
feeds
The inverter is designed to be dustproof in line with IP 65. However, in
areas with a heavy build-up of dust, the thermal efficiency may still be
impaired by dust forming on the cooling surfaces. Regular cleaning is
necessary in such situations. We therefore recommend not installing
the inverter in areas and environments with high dust accumulation.
The inverter is designed to be installed vertically on a vertical wall. The
optional fitting base must not be used for vertical installation.
The inverter should have a minimum inclination of 3° in a horizontal
installation position so that water can run off. Installing the optional fit-
ting base is recommended. The fitting base may only be used on an
installation position of 0 - 45°.