Completing The Installation; In Os/2 - Adaptec SlimSCSI APA-1460 Installation Manual

12
When Windows NT starts again, insert the Adaptec
EZ-SCSI 4.0 Setup Diskette in the floppy disk drive.
13
Click the Start button, and select Run.
14
Type a:\setup (or b:\setup if you are using the B
drive). Then click OK to install Adaptec EZ-SCSI.
15
When Adaptec EZ-SCSI is installed, continue with
Using the SlimSCSI Adapter on page 8.
Completing the Installation in OS/2
Follow these steps to complete installation of the
SlimSCSI adapter under OS/2 versions 2.0, 2.1, or 3.0
(Warp).
Note:
OS/2 must already be installed on the PC
before you begin these steps. OS/2 does not
support installation from a CD-ROM drive con-
nected to a PCMCIA card such as the SlimSCSI
adapter.
1
Be sure that the SlimSCSI adapter is inserted in a
PCMCIA slot and that the SCSI disk drive and/or
other SCSI devices are connected to it and are turned
.
ON
2
Start OS/2 and open the OS/2 System folder.
3
Select the Selective Install icon (in the
os!2_sys\system_s directory).
4
Click PCMCIA Support, select the PCMCIA system
appropriate to your PC, and click OK.
5
Click Install and follow the instructions that appear
on the screen. (You will be instructed to insert a series
of OS/2 diskettes.)
6
When the installation procedure is completed, click
OK.
7
Insert the Windows NT/OS2 Drivers diskette in
drive A.
8
Select the Device Driver Installation icon (in the
os!2_sys\system_s directory).
9
Click Install. The aha152x.add file is then installed
on your PC.
10
If you are installing a CD-ROM drive, select a
CD-ROM from the Selective Install icon.
11
If automatic installation completes, restart your PC.
The installation is now complete.
12
Continue with Using the SlimSCSI Adapter on page 8.
If automatic installation fails:
1
Use an editor to add these lines to config.sys. (Be sure
to place them before other basedev lines):
basedev=aha152x.add
basedev=os2scsi.dmd
7