Pro; Beeps - Adaptec SlimSCSI APA-1460 Installation Manual

Installing
CardWizard Pro
If your portable PC runs under Windows 3.1, you must install
the CardWizard Pro software before you install the SlimSCSI
adapter and Adaptec EZ-SCSI! CardWizard Pro, from
SystemSoft, enables your PC to recognize the PCMCIA
slot(s) and to automatically allocate system resources to
the SlimSCSI adapter and other PC cards. CardWizard
Pro gives your PC Plug and Play capability in both DOS
and Windows 3.1.
Follow these steps to install CardWizard Pro:
1
Remove any PC cards that are currently installed in
PCMCIA slots on your portable PC.
2
Insert the CardWizard Pro diskette in your PC's
floppy disk drive.
3
Start Windows, if it is not already running.
4
Select Run from the Program Manager File menu.
5
Type a:\setup (or b:\setup if you are using the B
drive), and click OK.
6
Follow the instructions that appear on the screen.
Refer to the CardWizard Pro online Help if you
encounter any problems during installation.
7
When you see a message asking if you want to restart
your PC now, click on Restart Now and wait until
Windows restarts.
When Windows restarts, you will see a message
warning you that the APA-1460 SlimSCSI adapter is
not configured.
8
Click OK. The main CardWizard screen appears, with
additional warning text. These messages are normal.
CardWizard will recognize the SlimSCSI adapter later
after you have installed Adaptec EZ-SCSI.
9
Exit from CardWizard and continue with Installing the
SlimSCSI Adapter on page 3.
2
CardWizard Pro System Beeps
When CardWizard Pro is installed, the PC sounds the fol-
lowing beep codes when you insert or remove a
PCMCIA card:
Medium tone followed by high tone—The card is recog-
nized and successfully configured.
Single low tone—The card is recognized but is not suc-
cessfully configured. You may need to change your
PC and/or CardWizard Pro configuration.
High tone followed by a medium tone— A card has been
removed.