Completing The Installation In Windows 95 - Adaptec SlimSCSI APA-1460 Installation Manual

Completing the Installation in
Windows 95
If Windows 95 Is Not Installed on Your PC
If Windows 95 is not already installed on your PC, install
it now and then continue with the instructions in the
next section, If Windows 95 Is Installed on Your PC.
Follow these steps if you need to install Windows 95
from a CD-ROM drive connected to your SlimSCSI
adapter:
1
Insert the SlimSCSI adapter in a slot, connect the
CD-ROM drive to it, and turn the drive
Be sure the CD-ROM drive is terminated, if it is the last
SCSI device on the bus.
2
Boot the PC to DOS and insert the Adaptec EZ-SCSI
Setup Diskette in the PC's floppy drive.
3
At the DOS prompt, type a:\dosinst (or b:\dosinst, if
the diskette is in the B drive) and press Enter.
4
Follow the instructions that appear on the screen.
EZ-SCSI will install the drivers required by your
CD-ROM drive.
5
When EZ-SCSI DOS installation is complete, reboot
your PC. Be sure the CD-ROM drive is still powered
when you do this.
ON
6
Insert the Windows 95 installation CD disc in the
CD-ROM drive and follow the installation instruc-
tions that appear on the screen.
7
When Windows 95 is installed on your PC, continue
with the following section, If Windows 95 Is Installed
on Your PC.
If Windows 95 Is Installed on Your PC
1
Start Windows 95 on your PC.
2
To ensure that the correct PCMCIA Card and Socket
Services are installed, open the Control Panel and
double-click on PC Card (PCMCIA). Then follow the
instructions that appear on the screen.
3
If the SlimSCSI adapter is not already inserted in the
slot, insert it now. If no prompt appears, continue
with step 4.
If you are prompted for APA-1460 adapter files, click
Browse and insert the Adaptec EZ-SCSI 4.0 Setup
.
ON
diskette in the floppy drive. Select the drive letter of
your floppy drive and click OK, then follow the
instructions that appear on the screen. (This step
ensures that the most up-to-date versions of drivers
are installed.)
4
Insert the Adaptec EZ-SCSI 4.0 Setup Diskette in the
floppy disk drive.
5
Click the Start button and select Run.
6
Type a:\setup (or b:\setup if you are using the B
drive). Then click OK.
7
Follow the instructions that appear on the screen.
8
When Adaptec EZ-SCSI is installed, remove the
Setup Diskette from the floppy disk drive.
9
We recommend that you install the CardWizard Pro
for Windows 95 software included with your Slim-
SCSI adapter. To do this, follow these directions:
a
b
c
10
Continue with Using the SlimSCSI Adapter on page 8.
Insert the CardWizard Pro for Windows 95 disk-
ette in the floppy disk drive.
Type a:\setup (or b:\setup if you are using the B
drive). Then click OK.
Follow the directions that appear on the screen.
Choose the defaults for a "typical" installation.
5