Station; Removing A Kreg 700-Series Jig From An Unmounted Docking Station - Kreg 700 Series Owner's Manual

Removing a Kreg 700-Series Jig from an Unmounted Docking

Station

a. Detach each material support wing (I):
1. Grasp the material support wing (I) close to where it connects to the dock
adapter (H).
2. Gently lift up the material support wing (I) so that the material-support-wing
connector (1) pops out of the dock-adapter connector (2).
b. For the dock adapter (H) on each side of the jig (A):
1. Lift that side of the jig (A) slightly off the work surface.
2. With the jig handle (3) facing you, slide the dock adapter (H) away from you
until the dock adapter (H) disengages from the slot on the underside of the
jig (A).
3. Pull the dock adapter (H) out from the underside of the jig (A).
20
A
I
1
2
H
3
A
H