Minelab GPX 6000 User Manual page 8

ML 100 Headphones Pairing Procedure
Pairing the ML 100 headphones is only required at first time use� They will automatically connect for all future uses�
Re‑pairing is required following a Factory Reset of either the headphones or the detector�
When Bluetooth® headphones are paired, the Bluetooth® Indicator will indicate the type of headphones that are in use�
Standard Bluetooth®
START `
1. Make sure headphones are off, and
close to the detector.
2. Turn on the headphones and
enter pairing mode.
3. Enable Bluetooth® on the detector
and enter pairing mode.
4. Headphones will
automatically connect.
To Factory Reset the ML 100 headphones, press the Multi‑Function button for more than 10 seconds� All previous pairings
and settings will be deleted�
CONTENTS
Bluetooth® Qualcomm® aptX™ Low Latency
Long press for at
least 7 s
Long press for at
least 2�5 s
8
Ensure the headphones are turned off and are no more than
1 metre (3�3 feet) away from the detector�
Press and hold the Multi‑Function button on the headphones
until two ascending tones are heard and the Status LED
alternates blue and red�
Press and hold the Bluetooth® button on the side of the
GPX 6000™ control panel until the Bluetooth® indicator begins
to flash rapidly�
For first-time use of the detector or following a factory reset, a
short press of the Bluetooth® button will immediately initiate the
pairing sequence.
If pairing is successful, the headphones will beep, and the
Bluetooth® and wireless headphones indicators will remain on�
The Status LED on the headphones will flash blue once every
3 seconds during use�