Minelab GPX 6000 User Manual page 18

Ground Balance Procedure (Continued)
Conductive (Salty) Ground `
7. Change to a Double‑D coil.
8. Turn the detector on.
9. Ensure the Double‑D mode is set to
Conductive Ground Cancel.
10. Quick‑Trak.
11. Adjust the sensitivity.
` Begin detecting.
CONTENTS
Turn off the detector and change to a Double‑D coil
(see "Changing the Coil"
Turn the detector back on�
To set the Double‑D mode to Conductive Ground Cancel, long
press the Noise Cancel button for at least 2�5 seconds�
Long press for at
least 2�5 s
Perform the Quick‑Trak procedure
Adjust the sensitivity level
Swing the coil close and parallel to the ground when adjusting
the sensitivity in order to remove ground noise�
18
on page 9)�
(page 16)�
(page 12)�