Getting Started; Quick Start - Minelab GPX 6000 User Manual

Getting Started

This section shows you how to quickly set up your detector to begin detecting with
minimal adjustment, and describes how to identify and adjust key detector functions�

Quick Start

Beginning with Factory Default Settings is
recommended before using this Quick Start procedure�
1
TURN
ON
2
RAISE AND LOWER
COIL FOR 10 s
3
BEGIN
DETECTING
CONTENTS
100 mm (4")
10 s
Factory Default Settings
The factory default settings are optimised for detecting in
almost all conditions� The settings are a practical choice for
users who want to begin successfully detecting without the
need to manually adjust detector settings�
Quick Start is best used with these factory default settings:
` Sensitivity: Auto
` Ground Type: Difficult
Factory Reset
Factory default settings can be restored at any time by
conducting a factory reset�
1.
Ensure the detector is powered off�
2. Press and hold the power button for 7 seconds�
3. When factory reset is complete, there is a confirmation
tone and 'FP' (Factory Preset) is displayed�
'FP' is displayed when factory reset is complete�
Achieving Maximum Depth
Maximum depth is achieved by having the Threshold
Tone on� To toggle the Threshold Tone on/off, long
press the Ground Type button�
See "Manual Sensitivity" (page 12)
on using the Threshold Tone when adjusting the manual
sensitivity to maximise detection depth�
3
for more information