Internal Scsi Devices - Adaptec AHA-2940UW/OF User Manual

Internal SCSI Devices

1
Install or enable terminators on the device that you plan to
install at the end of the internal cable. Then remove or disable
terminators on all remaining devices.
On most internal SCSI devices, you control termination by
setting a jumper or a switch, or by physically removing or
installing a resistor module(s). Refer to the device's
documentation to determine how to enable or disable
termination on your particular device.
This Device
Terminated
Figure 2-5. Installing Internal SCSI Devices
2
Install and mount each internal SCSI device inside your
computer. (Refer to your computer and device documentation
for instructions.)
Installation
2-5