Using Scsiselect; Selecting A Single-Chip Host Adapter With The P1275 User Interface - Adaptec AHA-2940UW/OF User Manual

Using SCSISelect

The SCSISelect utility enables you to change host adapter and SCSI
configuration settings directly from your computer's desktop.
SCSISelect also contains utilities that allow you to low-level format
or verify the disk media of your SCSI hard disk drives.
You can use SCSISelect directly from the P1275 User Interface.
Selecting a Single-Chip Host Adapter with the
P1275 User Interface
To select a single-chip host adapter with the P1275 User Interface:
1
Enter the system's Forth evaluator.
2
To display a list of attached devices, type the following
command at the ok prompt (also known as the Forth prompt,
Forth evaluator, or ROM monitor):
show-devs
3
From the ok prompt, select the Adaptec single-chip host
adapter to be configured. The word select is used to establish a
device instance for the adapter. For example, to select a single-
chip host adapter, type the following command:
select /pci/pci@2/scsi@4
Some systems may allow abbreviated forms of the device path
name for selection, for example:
select /pci/@2/@4
3
3-1