Adaptec AHA-2940UW/OF User Manual page 28

AHA-2940UW/OF and AHA-2944UW/OF User's Guide
environment of the other devices, the utility must make
assumptions for configuration settings based on the active
device.
To select a device
Press
When the device you want to configure appears at the
Select Host Adapter to Configure prompt, press Enter.
The top portion of the configuration screen (Host Adapter
SCSI ID and above) for the selected device appears. The
remaining options are displayed line-by-line as you set each
parameter.
Figure 3-3 shows the complete configuration screen for the
selected device.
--------------[AHA-294XU/UW/D - Bus
{<Space> to select settings
{<Enter> to accept setting
{!=select default setting
{@=select saved setting
{#=select previous setting
Host Adapter SCSI ID .......................... [
SCSI Parity Checking ..................... [
Support for Ultra SCSI Speed.............. [
Host Adapter SCSI Termination ............ [ AUTOMATIC ] (default)
Initiate Sync Negotiation -- SCSI ID [
Maximum Sync Transfer Rate - SCSI ID [
Enable Disconnection ------- SCSI ID [
Initiate Wide Negotiation -- SCSI ID [
Reset SCSI Bus at Host Adapter Initialization [
*Do you wish to save your settings? .... [ YES ] ..settings saved
Do you wish to reboot the system? ..... [
Do you wish to reinitialize the device? [ YES ] . device reinitialized
3-4
, or Space to scroll among the list of devices.
,
Figure 3-3. Device Configuration Screen
1 - Device 4]--------------
<Tab> to select device
<Esc> to abort configuration
F6=restore all default settings
F7=restore all saved settings
F8=restore all previous settings
ENABLED ] (default)
ENABLED ] (default)
0] [
0] [ 40.0 ] (default)
0] [
0] [
NO ]
7 ] (default)
YES ] (default)
YES ] (default)
YES ] (default)
YES ] (default)
}
}
}
}
}