Installing The Device Driver (Version 2.0 Or Later) For Solaris/Sparc 2.5.1; Installation From A Floppy Disk - Adaptec AHA-2940UW/OF User Manual

4
Install the host adapter device driver, as described in the
following section.
Installing the Device Driver (Version 2.0 or Later)
for Solaris/SPARC 2.5.1 or 2.6
You can install AHA-2940UW/OF and AHA-2944UW/OF device
drivers either from a floppy disk or from the Adaptec Web Site.
Follow the procedures below to install the device drivers.

Installation from a Floppy Disk

1
Log on to the Solaris operating system as root.
1
Insert the 7800 Family Open Firmware Manager Set, v2.0 device
driver installation diskette into the floppy drive.
2
At the superuser prompt (#), type the following command and
press Enter:
/etc/init.d/volmgt stop
3
Then type the following and press Enter:
pkgadd -d /dev/fd0
The following software package is displayed:
1 ADPadp
4
Select the package by typing 1 or all and pressing Enter to
install the device driver.
5
Press Y to answer yes to each question that follows.
6
When the following message is displayed, type q to quit the
installation:
Installation of <ADPadp> was successful.
7
Reboot the system to enable the new device driver to take
effect.
Adaptec 294X(U)W/394X(U)W/4944(U)W SCSI
Host Adapter Driver
(UltraSparc) release v2.00
Installation
2-9