Advertisement
Directives
ATTENTION!!
Read this manual carefully before installing the Spider Desktop!
Guarentee
No guarantee can be given if safety regulations are not followed.
Changes and/or modifications
Changes and/or modfications whch have not been approved by the responsible party can void
the user's authorty to operate the equitement.
Security
Always disconnect the power supply before handling anything inside the device.
For Indoor Use Only
This device may only be used indoors.
FCC Federal Communications Commission - US
This device is complies with part 15 of the FCC rules, operation is subject to two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, includng interference that may cause undesired operation.
CE Conformité Europeéne (Conform European Norm)
This device is in conformity with the EMC directive and low-voltage directive.
Conformité d'Industrie Canada
Appareil concernés:
Spider
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence.
L'exploitation est autorisée aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
RCM Regulatory Compliance Mark
This device is in conformity with Australian law.
End of life directives
Inepro is paying a lot of attention to environmentally-friendly production. Your new device contain materials which can be recycled
and reused. At the end of its life specialised companies can dismantle the discarded device to recycle the reusable materials and to
minimise the amount of materials to be disposed of. Please observe the local regulations regarding the disposal of packaging
materials, exhausted batteries and old requipment.
Confirm Canada Industries
Relevant Devices:
Spider
This device complies with Industry Canada's
licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of
the device.
Advertisement
