Table of Contents
Advertisement
PCI-DIO96H User's Guide
Connecting the board for I/O operations
Connectors, cables – main I/O connector
The table below lists the board connectors, applicable cables and compatible accessory boards.
Connector type
Compatible cables
Compatible accessory products with
the C100FF-x cable
The PCI-DIO96H board has a 100-pin, high-density Robinson-Nugent male connector. Connector pinouts are
listed on page 12. The C100FF-x cable can be used to split the 100 I/O lines into two, 50-pin cables.
Board connector pins 1 to 50 are mapped directly to pins 1 to 50 on the C100FF-x cable's first 50-pin connector.
Board connector pins 51 to 100 are mapped directly to pins 1 to 50 on the C100FF-x cable's second 50-pin
connector (pin 51 is mapped to pin 1, and pin 100 is mapped to pin 50.) A sample C100FF-x cable
configuration is shown in Figure 2 on page 13.
Information on signal connections
General information regarding signal connection and configuration is available in the Guide to Signal
Connections. This document is available on our web site at www.mccdaq.com/signals/signals.pdf.
Caution! When connecting a cable to the board's I/O connector, make sure that the arrow indicating pin 1
on the board connector lines up with the arrow indicating pin 1 on the cable connector. Incorrectly
connected cables can damage the board and the I/O controller.
Board connectors, cables, accessory equipment
100-pin, high-density connector
C100FF-x (Figure 1)
CIO-MINI50*
CIO-SPADE50*
CIO-TERM100
SCB-50
CIO-ERB24
CIO-SERB24/FD
CIO-ERB48
CIO-SERB48
SSR-RACK24
SSR-RACK48
* two devices are required
11
Installing the PCI-DIO96H
Advertisement
Table of Contents
Need help?
Do you have a question about the PCI-DIO96H and is the answer not in the manual?
Questions and answers