Installation And Operation; Connecting The Do2 To A Computer; Installing The Aqua4Plus Software - Seametrics DO2 Instructions Manual

INSTALLATION AND OPERATION

Connecting the DO2 to a Computer

The DO2 cable is terminated with a weather-resistant connector. Connect the
weather-resistant connector to your computer's USB port as shown below.
Sensor Cable
Cableless
Configuration
Sensor

Installing the Aqua4Plus Software

The Seametrics DO2 sensor comes with the Aqua4Plus host software that is installed
on your PC or laptop. Use this software to program the datalogger, to retrieve
data from the logger, to view collected data, and to export data to external files
for use with spreadsheets or databases.
Refer to the Aqua4Plus software manual for details on installing and using
Aqua4Plus.
Using the Sensor Without Aqua4Plus
Most users will use the sensor with Seametics Aqua4Plus software. However, this
sensor is quite versatile, allowing you to do the following:
•
Read via the Modbus
•
Read via SDI-12 protocol.
•
Display readings on a panel meter.
If you want to use one of these methods, see Appendix C or contact Seametrics
for further details.
Seametrics • 253.872.0284
Aux. Box
Cap
Sensor
Connect the sensor to an auxiliary power supply
then to your PC using USB to RS485 adapter.
protocol using your own software.
®
USB to RS485
Adapter
USB Port
Page 5
DO2 INSTRUCTIONS
PC or Laptop
seametrics.com