Plc Inputs; Plc Outputs; Analogue Plc Input (Set Point) - honle LED powerline AC/IC 410 Operating Instructions Manual

4.5. PLC inputs

The PLC inputs are electrically isolated by optocouplers.
Technical data of PLC inputs:
- PLC_Release
- PLC_ON
Max. approved voltage
Input current
Internal input resistance
ATTENTION! MATERIAL DAMAGE!
If the max. approved voltage at the PLC inputs is exceeded,
the PLC interface may be damaged.
4.6.

PLC outputs

The PLC outputs are electrically isolated by optocouplers. All outputs have
a common connection (SPSOUT_COM).
Technical data of PLC outputs:
Max. approved voltage
Max. approved output current
ACHTUNG! SACHSCHADEN!
Exceeding the above limit value may damage the PLC inter-
face. The PLC outputs are not resistant to continuous short-
circuit.

4.1. Analogue PLC input (set point)

The power of the LED unit can be varied from 5 – 100 % via the analogue
PLC input.
Technical data of analogue input:
Max. approved voltage
Adjustment range for 5-100%
Input resistance
ATTENTION! MATERIAL DAMAGE!
If the maximum approved voltage at the PLC inputs is exceed,
the PLC interface may be damaged!
#078734DE-EN e
input = 1 output = 0
20 – 30 VDC 0 – 5 VDC
–
max. 5 mA
16 kOhm
60 VDC
30 mA
30 VDC
0,5 – 10 V
> 100 kOhm
PLC inputs
PLC outputs
Analogue PLC
input (set point)
17