Installation, Commissioning And Power-Up; General Notes; Electrical Connections; Power Supply Unit - honle LED powerline AC/IC 410 Operating Instructions Manual

LED Powerline ACIC

4. Installation, commissioning and power-up

General notes

Electrical
Connections
Power supply
14
4.1. General Notes
 When installing the LED Powerline ACIC, make sure that there is
adequate cooling.
ture of up to 60 °C and may only be attached to heat-resistant, non-
flammable materials.
 The installation location must be sufficiently ventilated. Under no cir-
cumstances may the air inlets and outlets be covered or blocked
 Max. ambient temperature 35 °C.
 The operating unit must always be switched off before the LED Pow-
erline ACIC is connected to or disconnected from it! Disconnecting
the LED Powerline ACIC during operation can damage the LED unit
or the operating unit.
 Do not touch the contact pins in the LED Powerline ACIC plug con-
nector (danger of ESD damage).
 Protect the LED Powerline ACIC against chemical vapours and sol-
vents.
 Only operate the LED Powerline ACIC in dry rooms. Max. rel. humid-
ity 70 %; non-condensing. Open-air operation is not permitted.
 It should be observed that the unit is not exposed to any spray water.
Furthermore, no condensation may form on the surface of the unit.
 Before switching on, check again that all plug-in connections are
firmly seated.
 Observe workplace safety.
 Observe operational safety.
 Check the power of the lamp unit.
 It is forbidden to operate the device in the immediate vicinity of flam-
mable objects, liquids or gases.
4.2.

Electrical Connections

The LED Powerline ACIC is supplied with power and activated either via
 an external power supply unit and customer-side activation of the in-
terface with the PLD terminal or
 the Hönle LED Powerdrive IC
The LED Powerline ACIC may only be connected and disconnected with
the operating unit switched off.
4.3.

Power supply unit

A power supply unit is required to operate the LED Powerline ACIC:
The required values can be found in chap. 7 Technical data p. 23
In normal operation, the unit reaches a tempera-
#078734DE-EN e