Replacing An Io-Link Device; Introduction; Replacement Of An Io-Link Device (According To Io-Link Communication Specification V1.0) - Siemens SIRIUS 3RA6 System Manual

3RA64/3RA65 compact starter with IO-Link
6.3 Configuring
6.3.7

Replacing an IO-Link device

6.3.7.1

Introduction

To replace compact starters with IO-Link, the devices must be disconnected and isolated
from the communication. The complete group of load feeders becomes inactive. After
removal of the connections between the load feeders, the applicable module can be
replaced.
After the connections have been restored and communication has been resumed, the
parameterization can be restored according to the respective IO-Link communication
specification:
● IO-Link communication specification V1.0: concerning the IO_LINK_DEVICE function
block.
6.3.7.2 Replacement of an IO-Link device (according to IO-Link communication specification
V1.0)
Upon replacement of a compact starter with IO-Link, the plug-in connection to the IO-Link
port can be removed without isolating the control voltage supply.
Parameter data and configuration data specially optimized by the user for a specific
application are stored in an IO-Link-Device. This data deviates in many cases from the
default values stored in the IO-Link-Device.
In the event of replacement of an IO-Link-Device (referred to below as a "module"), the
optimized data must be transferred to the new module because the parameters are stored
only in the IO-Link device itself.
Data can be transferred via two channels:
● Module replacement with PG/PC
● Module replacement without PG/PC
Procedure with PG/PC
In the event of a replacement, a PG/PC is available with the SIMATIC project of the plant.
With the data stored in the SIMATIC project, and the
transfer the parameters belonging to the replaced IO-Link-Device to the new IO-Link-Device.
108
S7-PCT
port configuration tool, you
SIRIUS 3RA6 compact starter
System Manual, 08/2018, NEB560060102000/RS-AB/007