Accessories
7.12 AS-i mounting module for 3RA61/3RA62 compact starter
7.12.4
Installing/removal
7.12.4.1
Installing the AS-i mounting module
Requirements
NOTICE
Damage to the AS-i mounting module!
If you install the AS-i mounting module on a compact starter that has a control supply
voltage of more than 24 V, the AS-i mounting module will be supplied with too much power.
This will damage the AS-i mounting module.
Only install the AS-i mounting module on a compact starter with a control supply voltage of
24 V.
Note
Damage to the AS-i mounting module!
This will damage the AS-i mounting module if it is electrostatically charged.
Please observe the ESD regulations when working with the AS-i mounting module.
● The control circuit terminals must be removed from the compact starter (24 V) (for
information on removing the control circuit terminals, please refer to "Installing/removal
(Page 150)").
● The compact starter must be switched off (actuator set to
218
OFF position).
SIRIUS 3RA6 compact starter
System Manual, 08/2018, NEB560060102000/RS-AB/007