Operation - Toro Wheel Horse XT Series Operator's Manual

Danger
Without the grass deflector, discharge cover, or
complete grass catcher assembly mounted in
place, you and others are exposed to blade contact
and thrown debris. Contact with rotating mower
blade(s) and thrown debris will cause injury or
death.
Never put your hands or feet under the mower.
Never try to clear discharge area or mower
blades unless you move the PTO to Off and
rotate the ignition key to Off. Also remove the
key and pull the wire off the spark plug(s).
1. Install the grass deflector onto the mower with saved
hardware (Fig. 40).
2. Install the original belt cover onto the mower with
saved hardware (Fig. 40).
3
5
9
Figure 40
1. Grass deflector
2. Belt cover
3. Blade drive belt
4. Nut and lock washer
5. Single pulley
Removing the Mower Counterweight
1. Remove the bolts securing the counterweight to the
top of the mower (Fig. 30).
2. Remove the counterweight and save for use when
installing the bagger.
2
7
4 8
6
1
1836
6. Jam nut, 3/8 inch
7. Rubber bushing
8. Plastic washers
9. Torsion spring
1
2
7
6
5
Figure 41
1. Locknut 3/8 inch
2. Flat washer, 3/8 inch
3. Counterweight
4. Bolt, 3/8 x 2–1/4 inch
Leveling the Mower
Level the mower when the blower and counterweight are
removed. Refer the the mower Operator's Manual.

Operation

Note: Determine the left and right side of the machine
from the normal operating position.
Caution
To avoid personal injury, read and follow the
statements below.
Become familiar with all operating and
safety instructions in the operator's manual
for your tractor and mower before using
this attachment.
Never remove the discharge tube, bags,
bagger top, or the blower while the engine
is running.
Always shut the engine off before clearing
an obstruction from the vac bagging
system.
Never do maintenance or repairs while the
engine is running.
18
3
2
4
m–3687
5. Danger decal
6. Washout port
7. Belt cover