Toro Wheel Horse XT Series Operator's Manual page 9

Installing the Blower Pivot Support
1. Select the proper hole in the pivot support. Refer to
Figure 8 for the correct hole.
1
2
Figure 8
1. Pivot support
2. Mounting hole for a
42 inch mower
2. With the correct hole, slide the pivot support over the
threaded stud welded to front of mower near the
discharge opening (Fig. 9).
3. Align the pivot support parallel with front curved edge
and tight against top of mower (Fig. 9). Clamp in this
position.
4. Drill a 11/32 inch diameter hole into the top of the
mower using the pivot support as a template.
5. Secure the pivot support to the mower with a bolt
(5/16 x 3/4 inch), through from the underside of the
mower, and a flange nut (5/16 inch) (Fig. 9).
6. Install the jam nut (3/8 inch) (removed from the grass
deflector) snug onto the stud. Do not overtighten the
jam nut.
3
m–6630
3. Mounting hole for a
48 inch mower
7
1
6
2
1494
Figure 9
1. Pivot support
2. Mounting hole—42 inch
3. Mounting hole—48 inch
4. Jam nut, 3/8 inch
(removed from grass
deflector)
Installing the Height–of–cut Lever on
42 inch Mowers Only
Install a new height–of–cut lever on 42 inch mowers only.
1. Remove the cotter pin and washer from the rear
adjustable link (Fig. 10).
2. Remove the rear wheel bracket from the mower
(Fig. 10).
3. Slide the rear wheel assembly to the right, towards the
side discharge side (Fig. 10).
4. Remove the existing height–of–cut lever and spring
from the mower (Fig. 10).
5. Install the new height–of–cut lever and existing spring
to the wheel assembly (Fig. 10).
6. Slide the rear wheel assembly to the left, installing the
height–of–cut lever into the height–of–cut bracket
(Fig. 10).
7. Install the cotter pin and washer to the rear adjustable
link (Fig. 10).
8. Install the rear wheel bracket to the mower (Fig. 10).
9
5
3
4
8
5. Drill 11/32 inch diameter
hole
6. Bolt, 5/16 x 3/4 inch
7. Flange nut, 5/16 inch
8. Plastic washer (removed
from grass deflector)