Toro Wheel Horse XT Series Operator's Manual page 13

Installing the Belt Cover on 48 inch
Mowers
1. Mount the belt cover bracket into the holes used by the
original cover with 2 thread forming flange screws
(1/4 x 1/2 inch) (Fig. 21).
2
1
Figure 21
1. Belt cover
bracket—48 inch
2. Mount the belt cover loosely on top of the mower with
3 flange screws (1/4 x 1/2 inch) (Fig. 22).
Note: Do not tighten the screws as an adjustment must be
made later.
1
2
Figure 22
1. Belt cover—48 inch
Installing the Blower Belt Cover
1. Mount the blower belt cover using 2 bolts (1/4 x
5/8 inch) and 2 locknuts (1/4 inch) (Fig. 23).
Note: Tighten the locknuts slightly so light drag is felt on
the belt cover when tilted upward. The cover must close
freely when assembled.
2
m–6643
2. Flange head,
1/4 x1/2 inch, thread
forming
2
m–6645
2. Flange screws, 1/4 x
1/2 inch, thread forming
13
1
2
Figure 23
1. Blower belt cover
2. Bolt, 1/4 x 5/8 inch
2. Adjust the blower belt cover so that the L brackets rest
on pulley plate. Tighten the blower belt cover
mounting screws (Fig. 24).
1
Figure 24
1. Blower belt cover
2. Pulley plate
3. Tighten the mower belt cover mounting screws
(Fig. 20 and 22).
4. Install the mower to the tractor. Refer to Installing the
Mower in the mower Operator's Manual.
Installing the Bagger Assembly and Bags
1. Slide the bottom of the quick-attach bracket down into
the hole in the hitch and hook the notches onto the
spacers located inside the tractor frame (Fig. 25).
2. Slide the cotter pin through the hole at the bottom of
the quick-attach bracket (Fig. 25).
2 & 3
4
3
1997
3. Lock nut, 1/4 inch
4. Mower belt cover
4
3
2
m–5083
3. L brackets
4. Front wheel