Toro Wheel Horse XT Series Operator's Manual page 10

7
4
3
5
m–6646
Figure 10
1. New height–of–cut lever
2. Spring
3. Washer
4. Cotter pin
5. Rear wheel bracket
Assembling the Blower
1. Install the long hook end of the tension spring and a
nut (#10) onto a bolt (#10 x 3/4 inch). Thread the nut
within an 1/8 inch (3 mm) from the head of the screw
to allow space for the spring to rotate freely (Fig. 12).
2. Slide a washer (#10) onto the screw and insert it
through the blower housing. Install a second washer
(#10) and nut (#10) onto the bolt (Fig. 12).
3. While holding the first nut, tighten the second nut so
that the assembly is tight against the plastic housing.
4. Select the appropriate latch. Refer to Figure 11 for the
correct latch.
2
m–6669
Figure 11
1. 42 inch mower latch
5. Hook the spring into the hole in the latch and mount
the latch to the blower housing with a bolt (1/4 x
3/4 inch), washer (1/4 inch), and locknut (1/4 inch)
(Fig. 12). Leave the nut loose enough so that the latch
pivots freely.
1
9 2
8
6. Rear wheel assembly
7. Rear adjustable link
8. Side discharge
9. Height–of–cut bracket
1
2. 48 inch mower latch
8
7
3
4
1496
Figure 12
1. Bolt, #10 x 3/4 inch
2. Spring
3. Nut #10
4. Washer #10
5. Latch
Assembling the Bagger Cover
1. Slide the threaded end of the indicator rod through
2 clips, the rubber seal, and the slot in the cover
(Fig. 13).
2. Secure the clips to the cover with 2 pan head screws
(1/4 x 5/8 inch) and 2 locknuts (1/4 inch) (Fig. 13).
3. Thread the jam nut and handle completely onto the
threaded end of the indicator rod.
4. Rotate the handle so that the decal can be read from
the operators position, then tighten the jam nut
(Fig. 13).
10
9
5
2
6
1
4
3
6. Bolt, 1/4 x 3/4 inch
7. Washer 1/4 inch
8. Lock nut 1/4 inch
9. Blower assembly