Table of Contents
Advertisement
5.4 Setting the menu
If Intellectual Stack with RS-232C connection is used, observe the following.
When inputting image signals to Sub using Main, the operations differ between
using computer signals and video signals such as component and video signals.
Inputting an image from Main to Sub - Computer signal
1.
If the STACK menu is already displayed on the screen, proceed to step 3
below. Otherwise press the MENU button on the remote control.
If the MENU dialog is displayed, use the ▲/▼ buttons to
highlight MAIN, and press the ► button. A menu is
displayed.
If the MENU dialog is not displayed, the STACK menu appears.
2.
Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION > STACK
STACK menu appears on screen.
(Operating Guide
3.
Use the ▲/▼ buttons to highlight SUB INPUT
SOURCE, and press the ► button to display the
SUB INPUT SOURCE dialog.
4.
Use the ▲/▼ buttons to highlight FIXED (COMPUTER IN), and press the ►
button to complete the setting. ( 20 )
5.
Press any button to select an input port on the remote
control or the INPUT button of the Main projector.
The MAIN INPUT SOURCE dialog is displayed on screen.
Use the ▲/▼ buttons to highlight the port to which the
signal cable is connected, and press the ► button to
complete the setting.
• When FIXED (COMPUTER IN) is selected, input sources other than
NOTE
COMPUTER IN cannot be selected.
• When FIXED (COMPUTER IN) is selected, if any button to select an input port
on the remote control or the INPUT button on the Main projector is pressed, the
dialog for selecting the input source is displayed.
→
OPTION
menu)
29
Setting input ports using menu
QM00974-1
Advertisement
Table of Contents
