Setting The Menu; Inputting Image From Main To Sub - Computer Signal - Hitachi CP-X8150 User Manual

5.4 Setting the menu

If Intellectual Stack with RS-232C connection is used, observe the followings.
When inputting image signals to Sub via Main, the operations differ between using
computer signals and video signals such as component and video signals.

Inputting image from Main to Sub - Computer signal

1.
If the STACK menu is already displayed on the screen, proceed to 3 below.
Otherwise press the MENU button on the remote control.
If the MENU dialog is displayed, use the ▲/▼ buttons to
highlight MAIN, and press the ► button. A menu will be
displayed.
If the MENU dialog is not displayed, the STACK menu will appear.
2.
Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION > STACK
STACK menu will appear on screen.
(Operating Guide
3.
Use the ▲/▼ buttons to highlight SUB INPUT
SOURCE, and press the ► button to display the
SUB INPUT SOURCE dialog.
4.
Use the ▲/▼ buttons to highlight FIXED (COMPUTER IN 1), and press the ►
button to complete the setting. ( 19 )
5.
Press any button to select an input port on the
remote control or the INPUT button of the Main
projector. The MAIN INPUT SOURCE dialog is
displayed on screen. Use the ▲/▼ buttons to
highlight the port to which the signal cable is
connected, and press the ► button to complete
the setting.
• When FIXED (COMPUTER IN 1) is selected, the MONITOR OUT
NOTE
setting is invalid.
• When FIXED (COMPUTER IN 1) is selected, input sources other than
COMPUTER IN1 and COMPUTER IN2 cannot be selected.
• When FIXED (COMPUTER IN 1) is selected, if any button to select an
input port on the remote control or the INPUT button on the Main projector is
pressed, the dialog for selecting the input source will be displayed.
→ OPTION
(Operating Guide
Setting input ports using menu
menu)
→ SETUP menu)
27