Lutron Electronics PALLADIOM Configuration Manual page 39

Appendix C: User Interface for the Thermostat
Once the system is configured, verify the user interface and functionality of the thermostat.
The following steps illustrate details about the user interface of the thermostat.
1. Press the button to cycle through the different available fan modes. The fan modes cycle through only those modes which are
selected during configuration.
Symbol on the
Fan Mode
Thermostat
Low
Medium
High
On
On
Auto
Auto
2. Press the button to toggle the schedules between On and Hold.
Schedule Symbol on the
Status Thermostat
On
On
Off
Hold
The schedule will be enabled only if a HomeWorks QS processor is connected to the thermostat. In standalone systems (thermostat and
SMC55-HWQS without the HomeWorks QS processor), when pressing the
but will change back to the default 'Hold' state after two seconds.
3. Press the button to cycle through the different operating modes.
Operating Symbol on the
Modes Thermostat
Heat
Heat On
Cool
Cool On
Auto
AUTO
Off
OFF
Auxiliary
Only
only
Aux Heat On
The operating modes cycle through only those modes that are selected during the installation.
4. In the Heat operating mode, press the
5. In the Cool operating mode, press the
Continued on next page...
buttons to increase or decrease the heating setpoint temperature.
buttons to increase or decrease the cooling setpoint temperature.
39
button the schedule will toggle between 'Hold' and 'On'
P/N 032498h